iD TX1 Tricopter by Gear127

by gear127 | February 10, 2014 | (5) Posted in Projects

Hi everyone,

This is a short introduction to my tricopter. Basically I designed the center frame plates of TurboCAD and had them cut out of 4mm thick acrylic ( waiting on my FP4 sheet) at a local sign shop on their 2-axis cutter. The arms, motor mounts and all mounting pieces for the arms are Tarot 16mm accessories. In all the frame cost about USD $50 to build here in Chengdu China.

Power and Flight control:

APM 2.6 w/ 6H GPS

1045 props

2217 - 950kv motors

Hobbywing 30A ESCs

Metal gear servo

3S 4200 mah

 

FPV equipment:

AEE S51 camera

5.8GHz 200mw Tx

cloverleaf antenna

11db patch Rx antenna 

WFT09 2.4GHz Radio transmitter 

 

 

Hope everyone likes it. .dwg

COMMENTS

Trauma50 on March 6, 2014
Nice job. How did you make the Yaw Mech with Tarot parts? Just looked at their web page, they don't even make a Tri? Thanks
Log In to reply
gear127 on March 7, 2014
you can see the yaw mechanismI bought from Taobao here.

h5.m.taobao.com/awp/core/detail.htm?id=36387835618&rn=8L78H0MB2-XkERN0xg766PG06CD8-UwoZoXO-Ax3C&sid=c5e4570cdfce4341&abtest=7

the Mechamism bolts to the standard tarot motor mount.
Log In to reply
Trauma50 on March 7, 2014
Thanks
Log In to reply
Trauma50 on March 7, 2014
Could not find the English translation button on the web site?? My Chinese is a little rusty/non existent. I've seen similar ones on Ebay though, thanks again.
Log In to reply
nathanb62 on March 6, 2014
Yeah!!! Lets see some pics of the yaw mechanism!!!
Log In to reply
artemen on May 5, 2014
Hey, are you planning on producing the frame? if no could you share the plans?
Log In to reply
gear127 on May 19, 2014
Sure thing.
Log In to reply
kovacsadam on August 23, 2015
Hi!
Awesome frame idea-- can u share or send the CAD file? plz.. ty!!
Log In to reply

You need to log-in to comment on articles.


iD TX1 Tricopter by Gear127